Wysiwyggler Serge Patches
New Patch
Inventory
Compare Panels
Back
Save and render
Admin token
patch.def
(patch (canvas (width 4080) (height 5028) (background "/assets/serge_symbolic_joined.svg")) (point audio.aux-in 4004 2703 audio "Audio Interface AUX IN") (point gtsa.end-out 2865 2794 audio "GTS XL upper END OUT") (point gtsa.trig 2865 2884 audio "GTS XL upper TRIG IN") (point mixpro2.in1 3486 1956 audio "Edelweiss right Mix Pro IN 1") (point mixpro2.out 3486 1776 audio "Edelweiss right Mix Pro OUT") (point vcfq.band.out 1845 99 audio "VCFQ BAND") (point vcfq.trig 1965 369 audio "VCFQ TRIG IN") (cable c1 clock gtsa.end-out gtsa.trig (label "GTS XL upper END OUT -> GTS XL upper TRIG IN")) (cable c2 clock gtsa.end-out vcfq.trig (label "GTS XL upper END OUT -> VCFQ TRIG IN")) (cable c3 audio vcfq.band.out mixpro2.in1 (label "VCFQ BAND -> Edelweiss right Mix Pro IN 1")) (cable c4 audio mixpro2.out audio.aux-in (label "Edelweiss right Mix Pro OUT -> Audio Interface AUX IN")) )
notes.md
# VCFQ water drops A slow pulse excites the VCFQ directly. The filter supplies the decaying sound; no oscillator is needed. ## Start here Lower the monitoring level before patching. These are documented patch designs, not claims of hardware audition. Unless this recipe uses the right Mix Pro for control voltage: center its DC offset, zero unused channels, and bring up only the cabled audio inputs. Connect Audio Interface MIX OUT to your normal monitoring chain. 1. GTS upper: about one cycle per second, with a visible rise and a longer fall. 2. VCFQ: HIGH/audio range, signal inputs empty; raise Q until each trigger rings, then tune FREQ. ## Cables 1. GTS XL upper END OUT → GTS XL upper TRIG IN. 2. GTS XL upper END OUT → VCFQ TRIG IN. 3. VCFQ BAND → Edelweiss right Mix Pro IN 1. 4. Edelweiss right Mix Pro OUT → Audio Interface AUX IN. ## Listen for Separated hollow plinks whose pitch and decay are set by the filter. ## Play it Move Q from dry clicks to overlapping decays while gradually slowing the clock. ## If it misbehaves A continuous tone means Q/feedback is too high; silence may mean LOW range or Q too low. ## Module references - https://serge-modular.com/docs/RandomSource_Serge_VCFQ.pdf
Upload audio/video/image
Upload