# Breathing waveshaper NTO triangle audio passes through one actual TWS channel while a slow GTS changes its transfer curve. ## Start here Lower the monitoring level before patching. These are documented patch designs, not claims of hardware audition. Unless this recipe uses the right Mix Pro for control voltage: center its DC offset, zero unused channels, and bring up only the cabled audio inputs. Connect Audio Interface MIX OUT to your normal monitoring chain. 1. Tune NTO to a comfortable low-mid drone. Start TWS channel 1 input level low and +1 fully down. 2. Set GTS upper to a 4–8 second cycle. Start TWS CV 1 depth at zero and increase until the timbre moves. ## Cables 1. GTS XL upper END OUT → GTS XL upper TRIG IN. 2. NTO TRIANGLE → TWS IN 1. 3. GTS XL upper OUT → TWS channel 1 CV 1. 4. TWS OUT 1 → Edelweiss right Mix Pro IN 1. 5. Edelweiss right Mix Pro OUT → Audio Interface AUX IN. ## Listen for A steady pitch with periodic shifts in harmonic emphasis; the waveshaper is not a pitch sequencer. ## Play it Raise +1 for a second shaping stage, then reduce CV depth to keep a recognisable center. ## If it misbehaves No change: check that the cable enters IN 1, not New Ring SIGNAL IN on the far right. ## Module references - https://serge-modular.com/serge_4x4?mod=RS_TWS4X4